发布时间：2018-11-26 11:23:51 发布来源：http://www.jundazhuangshi.com
Jinan Home Decoration and Fitment Company Talking about Attentions to Ceramic Tile Destruction:
Notes for tile laying:
1. Ceramic tile consumption should be sampled before laying, to see the grade. If the color difference is different from the sample you see, if it is correct, it is better to let the construction agent sign for it, or tell the tile seller immediately;
2. Assuming that the wall surface is putty wall or calendered cement wall, it must be eradicated and roughened first. Wall bricks shall not be less than 1/3 bricks;
3. The air should be watered sufficiently, the degree lines on the walls and the layouts on the ground should be pre-arranged to ensure that the low bricks in the rooms are on the same level.
4. Dry paving is the best method for floor tiles.
5. Bathroom floor tiles should be better reserved for about 1% of the slope, and less than the inside floor tiles about 10 mm. The slope of kitchen floor tiles should be reduced appropriately.
6. When meeting the sun angle, 45 degrees cut angle should be adopted, and the lower edge of the waist line should be the upper edge of the window.
7. After 3-5 days of wall tile paving, drilling holes will be done again, and the next day after the dry floor tile paving, the construction will be done again.
Notes for wall tile paving:
1. Before laying, first of all, the grass-roots treatment should be done to clean up all kinds of dirt on the wall, and water it wet one day earlier.
2. The subsidy line for wall tiles should stop selecting and soak for more than 2 hours to dry the surface water for reserve.
3. Stop laying out and arranging bricks before laying. Non-whole bricks should be discharged in the main parts or shade corners. It is better to lay whole bricks from the bottom to the top to ensure the decoration effect of the whole toilet. Each wall should not have two rows of non-integer numbers, and the width of non-integer bricks should not be less than 1/2 of the whole brick. When sticking wall bricks, it should be noted that half of the bricks should be placed at the top, and the width of the cracks of the bricks should be 2-4MM.
4. Cement mortar should be fully laid on the opposite side of the brick, and one wall should not be laid to the top at one time in order to prevent collapse.
5. Because the kitchen and toilet pipeline is easy to deform and form brick cracks, stainless steel bar can be used at the positive corner of the wall brick.
Attentions for air brick laying:
1. Brick in the air should be wet before paving.
2. The thickness of mortar in the bonding layer should be determined according to the design requirements before laying, and the thickness of the bonding layer and the surface smoothness of the aerial bricks should be controlled by pulling cross lines.
3. When laying bricks in the air, we should stick to the position of degree, strike them with rubber hammer to make them bond tightly with mortar, and adjust their surface smoothness and seam width. The seam width is usually 3-5MM.
4. According to the orientation of the brick, laying line by line, the proportion of mortar is 1:3, and the thickness of mortar is 15-20MM.
5. Each pavement should be covered with about 10 bricks, reflecting the surface smoothness and gradient with a ruler, adjusting the cracks of the bricks appropriately and sticking to the cleaning of the bricks.
6. When laying floor tiles in toilets, a certain slope should be adhered to along the drainage position to ensure smooth drainage in the future.
This article is organized by Jinan Junda Decoration Co., Ltd. http://www.jundazhuangshi.com. We will provide you with the knowledge of Jinan Home Decoration Company. Interested friends can pay attention to us. Thank you!