济南家装装修公司教您水电装置的根本知识 - 新闻信息
公司简介 | 加入收藏 您好!欢迎来到济南骏达装饰有限公司官方网站!

效果图展示

当前位置:Product

首页 > 新闻动态 > 新闻信息 >
济南家装装修公司教您水电装置的根本知识
Jinan Home Decoration Company teaches you the basic knowledge of hydropower plant
1.水管管道开槽
1. Water pipe grooving
施工办法.先弹线再开槽。管路开槽依照要求一定要事平行线或许垂直线,比方有水电施工图的对照施工图更好一些。需求平行走线的管道必需控制在60-90厘米高的中央,有水龙头的管道必需是垂直的。深度控制在四厘米左右。线槽开好之后施工人员一定要记好开槽管路的尺寸以及地位。方便前期洁具装置时确定管路的详细地位。
Construction method. First spring line and then slot. Pipeline grooving must be parallel or vertical as required, which is better than the comparative construction drawings with hydropower construction drawings. Parallel pipelines are required to be controlled in the center of 60-90 cm high, and pipes with taps must be vertical. The depth is controlled about four centimeters. After the groove is cut, the construction personnel must remember the size and position of the grooved pipeline. It is convenient to determine the detailed position of the pipeline when the pre-cleaning device is installed.
2.水管管道装置
2. Pipeline installation
装修资料要求.PPR管.铝塑管。三年前很多人都喜欢运用铝塑管,这两年运用PPR管比拟多。管道有分爲冷水管和热水管两种,隐藏的管道相对不可以用镀锌铁管。
Decoration information requirements. PPR pipe. Aluminum plastic pipe. Three years ago, many people liked to use aluminium-plastic tubes. In the past two years, PPR tubes have been used more than others. There are two kinds of pipes: cold water pipes and hot water pipes. The hidden pipes can not be used with galvanized iron pipes.
施工图旱路功用不合理的话,一定要与业主沟通并添加旱路的运用功用。
If the function of dry road is unreasonable, we must communicate with the owners and add the function of dry road.
3.水管管道反省
3. Pipeline Reflection
旱路管道反省是至关重要的,这影响到当前的旱路平安隐患成绩。我们常常采用试压的办法来反省管道能否有渗漏景象。试压是反省办法之一,先采用堵头将一切的内丝堵住,之后用压力表打压试水。打压之后反省一切的管道以及接头地位能否有漏水景象。另一种办法就是堵上之后,翻开水阀二天二夜,第三天来反省一切的接头地位检查能否有漏水状况。
Reflection on dry road pipeline is very important, which affects the current achievements of hidden dangers of dry road safety. Pressure testing is often used to reflect on whether the pipeline can leak. Pressure test is one of the ways of reflection. First, all the wires are blocked by a plug, and then the water test is pressed by a pressure gauge. After the pressure, reflect on all the pipelines and joint status whether there is leakage. Another way is to open the valve for two days and two nights after the plug is blocked. On the third day, come to reflect on the status of all the joints to check whether there is leakage.
济南家装装修公司
4.二次防水
4. Secondary waterproofing
旱路管道装置之后,用水泥砂浆混合封好卫生间一切的线槽。等到线槽与空中干透之后,再次清洁空中以及墙面,墙面水分干透后就可以做防水了,墙面防水应该高达一米。假如卫生间反面有家具或许家电的话,必需做满墙。以防家具受潮,空中在做好防水之后需求填渣。填渣十厘米以上的用水泥砂浆干混来铺填。做二次防水空中与墙面应该一同做。
After the dry road pipeline installation, mix cement mortar to seal all the troughs in the bathroom. When the groove and the air are dry, clean the air and the wall again. After the water on the wall is dry, it can be waterproof. The waterproof on the wall should be as high as one meter. If there is furniture or household appliances on the opposite side of the toilet, it must be made full of walls. In case of damp furniture, the air needs to be filled with slag after waterproofing. Slag more than ten centimeters is paved with cement mortar. Do secondary waterproof air and wall should be done together.
5.电线线路开槽
5. Cable slotting
济南装修公司的施工人员在与业主磋商好用电功用以及要求后,与电工徒弟来交底,弹好平行与垂直的线槽。安顿好开关插座之后,插座应该在离空中40厘米的地位开槽,壁挂空调插座应该间隔空中2.2米的地位开槽,开关间隔空中1.2-1.4米的地位开槽。开关插座配合装置要弹程度线来开槽。卫生间需求结合运用功用来停止弹线开槽。
After consulting with the owner to make good use of the power and requirements, the builders of Jinan Decoration Company and the electrician apprentices come to the bottom and play the parallel and vertical slots. After installing the switch socket, the socket should be slotted 40 centimeters away from the air, the wall-mounted air conditioning socket should be slotted 2.2 meters apart from the air, and the switch should be slotted 1.2-1.4 meters apart from the air. Switch socket fittings should be grooved by elastic degree lines. The bathroom needs are combined with the use of power to stop the slotting of elastic wires.
6.电线电路布线
6. Wire and circuit wiring
资料的选择要求.2.5-6平方米的铜芯线.16毫米以上的线管。布线要求:大局部电工徒弟在电路电线布线中,没有思索到强电与弱电.开关.空调插座和电器插座需求分开走线。因而开槽也可以节省少量的费用。强电与弱电布线要求应该相隔30厘米,空调公用插座爲6平方以上的电线分组,电器公用插座爲4平方的电线,开关则爲2.5平方的公用分组。空调线间隔空中2米的地位走线。电器线在空中走线,开关以及照明零碎的线组在墙面或许顶面走线。开关插座在装置的时分必需是程度或许垂直的,这样使得前面的面板装置愈加平整。厨房的开关以及插座必需结合橱柜的运用功用来停止综合布置与装置。因而电线在布置好之后,施工工人记载好线路的布置以及布置尺寸,这样方便前期各种装饰品以及家具的装置。
Data selection requirements. 2.5-6 square meters of copper core wire. 16 mm above the line tube. Wiring Requirements: Most of the electrical apprentices do not think about strong and weak electricity. Switches. Air conditioning sockets and electrical sockets need to be separated. Therefore, slotting can also save a small amount of costs. The wiring requirements of strong and weak electricity should be 30 cm apart, air-conditioning public sockets should be grouped into groups of more than 6 square wires, electrical public sockets should be 4 square wires and switches should be grouped into groups of 2.5 square wires. The air conditioning line is 2 meters apart in the air. Electrical wires are wired in the air, switches, and fragmented sets of lighting are wired on walls or roofs. Switch sockets must be vertical or horizontal when they are installed, so that the front panel device is more flat. The kitchen switch and socket must be combined with the cabinet function to stop the comprehensive arrangement and device. Therefore, after the wires are laid out, the construction workers record the layout and layout dimensions of the wires, so as to facilitate the installation of various decorations and furniture in the early stage.
以上内容有济南骏达装饰有限公司提供,对济南家装装修公司感兴趣的朋友可以关注我们:http://www.jundazhuangshi.com请期待更多知识内容。
The above content is provided by Jinan Junda Decoration Co., Ltd. Friends interested in Jinan Home Decoration Co., Ltd. can pay attention to us: http://www.jundazhuangshi.com, please look forward to more knowledge content.


上一篇:卫生间装修不能错的装修知识
下一篇:在室内装修中极容易被无视的细节
  • 济南家装装修留...
  • 济南装修规划公...
  • 济南家装装修定...
  • 济南家装装饰越...
  • 济南家庭装修知...
    • 返回顶部
    • 15806619313
    • 微信二维码
      关注你附近